Modern wire ropes are made from four primary components: You might get away with a nut on just one side, but tightening it against the cable might sheer the cable.Wire rope is a rope constructed of metal wire strands braided together around a core. Then tighten the nuts against the cable to lock it in place. Pass the cable through the hole and bind the end with something like heat shrink tubing. Pre-position nuts above and below the hole. If the threaded rod is a much bigger diameter than the cable (on the order of three or four times or more), drill a clearance hole through the rod at the cable locations. Again, you could position it on the rod with a nut on each side.Īnother approach: this would be similar to the old binding posts used for speaker connections. The terminal would go on the end of the cable and the threaded rod would go through it. Steel cable doesn't compress like copper wire, so you would need a heavy-duty crimper. If there won't be any stress on the cable, you might be able to use a really large crimp-on loop-type electrical terminal. You would still need to deal with the end of the cable to secure it and keep it from unraveling (and protect yourself from stab wounds the ends are sharp). You mention an approach where you just pass the end of the cable through a hole. It won't be nearly as strong as a hardware clamp, but it will hold well enough for "decorative" purposes. Then cover the "clamp" with heat shrink tubing, making sure you enclose the cut end of the cable. Make the loop and bind it together by winding a piece of wire around the two a bunch of times. Just loop the cable around the rod, and use a nut on each side to keep it positioned where you want it.Īctually, you can clamp a steel cable loop together without a hardware clamp. Since you need a loop, anyway, you could skip a separate cable clamp to pass it through for attachment to the rod. This type of clamp is pretty streamlined and doesn't need special tools (it comes in various sizes for the cable): There are clamping U bolts, that only need a wrench, but they are ugly honking things to leave visible. There are crimp-on clamps that are basically a metal tube, but you need a heavy-duty crimping tool. Most of the attachment methods I can think of will require making a loop in the cable to go through or around something.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |